Garage Door Not Closing Totally On One Sid

If you need to change their tensions move them to a new hole.

Garage door not closing totally on one sid.

If one of them is off or blinking it means the invisible beam that tells the opener that the way is. If one side of the door is not in line with the other the door won t run smoothly in its tracks and when closed one side of the door won t close completely leaving an open gap. Your garage door opener may tell you this by showing a blinking light. Springs are one of the main causes of malfunctioning garage doors.

2 the safety sensors for your garage door located near the floor on each side of the garage on the tracks may have become out of alignment. All you will have to do in this case is readjust the sensors to allow the garage door to fully close. Side mounted extension springs are installed above the horizontal roller tracks on both sides of the door. The extension springs are evenly matched and installed to keep the garage door properly aligned so that it runs smoothly throughout the entire length of the track and closes evenly.

A roll up door also has springs on each side that is controlled by a pulley. There are usually two springs on each side of the garage door to swing it up. First check the sensor lights. Clutter or obstructions that block the sensor are the first problems to look for if your door won t close or in extreme cases open at all.

There is one on each side of the door. If the door stops and reverses near the bottom the problem may lie with the safety sensors. If your door has a gap.