Simply hold down the lock button on the wall control for about two seconds to disengage the lock.
Garage door not closing light flashing.
Once you see the double flash press the control button on the remote control.
First check the sensor lights.
Okay now that you know some of the common signs of garage door sensor malfunction you re ready for the next step troubleshooting.
If motor unit activates replace door control.
You may want to check the back of the motor unit.
In order to fix this you ll want to make small changes to the close limit setting until the door opener knows to stop once the door has reached the floor.
Once you push this button the light on the garage door opener will flash twice.
If the light flashing persists then the problem may be wire related.
Disconnect wires at door control touch wires together.
If your garage door opener is still blinking try realigning the safety reversing sensors.
The blink rate on the garage door opener service light points to various error codes.
This is a common garage door safety feature that prevents injury and damage to personal belongings.
If anything interrupts this beam of light the garage door will not close and the ceiling light on the opener mechanism will flash as mentioned in the previous step.
Lights on garage door opener flash and door will not close garage door light flashing but won t close when you see you garage door opener lights flashing and the garage door will not close it could be the lock button or the safety reversing sensors.
If your garage door sending sensor is showing a yellow light and the other does not show a green light it is likely they are misaligned.
The remote control will not work.
The back of the motor has a circuit board with a service light as well.
This is of course a safety feature to prevent the heavy garage door crushing anyone or anything that might be in the pathway of the door when it comes down.
To unlock your garage door opener push the lock button for 5 seconds.
Depending on the brand.
If your garage door is closing fully and then reversing to open again then it may be due to a problem with the close limit switch.
If motor unit does not activate disconnect door control wires from motor unit.
Inspect door control wires for a short staple in wire replace as needed.
Led is not lit on door control.
Other signs include flashing garage door opener lights missing sensor light or flashing sensor lights.
Only the button on the wall control or manual keypad inputs will open it.
The locking feature is meant to prevent garage door remotes from opening your door.
Garage door sensor locations.
